Id Registration With Transmitter Activation Tool

WARNING: This page is about a different car, the 2007 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: This procedure must be done after replacement of a low tire pressure warning transmitter or BCM.

New replacement transmitters are provided "asleep" and must first be "woken up" using Transmitter Activation Tool J-45295 before ID registration can be performed.

Connect CONSULT-II. Refer to "CONSULT-II START PROCEDURE ".
Select "AIR PRESSURE MONITOR" on "SELECT TEST ITEM" screen.
Select "WORK SUPPORT" on "SELECT DIAG MODE" screen, and select "ID REGIST".

Fig 1: CONSULT-II Display - SELECT DIAG MODE
Courtesy of NISSAN MOTOR CO., U.S.A.
Push the transmitter activation tool against the tire near the front left transmitter. Press the button for 5 seconds.
Tool number: (J-45295)

Fig 2: Identifying Transmitter Activation Tool
Courtesy of NISSAN MOTOR CO., U.S.A.

Register the IDs in order from FR LH, FR RH, RR RH and RR LH. When ID registration of each wheel has been completed, a buzzer sounds and the hazard warning lamps flash.

HAZARD WARNING LAMPS FLASH REFERENCE

Activation tire position		Buzzer	Hazard warning lamp	CONSULT-II
1	Front LH	Once	2 times flashing	"YET" ↓ "DONE"
2	Front RH	2 times
3	Rear RH	3 times
4	Rear LH	4 times

After completing all ID registrations, press "END" to complete the procedure.
NOTE: Be sure to register the IDs in order from FR LH, FR RH, RR RH, to RR LH, or the self-diagnostic results display will not function properly.