LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2004 >> Altima S, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 890 (Engine Cooling System) >> Thermostat And Thermostat Housing >> Removal and Installation >> Removal

Removal and Installation: Removal

WARNING: This page is about a different car, the 2007 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove engine undercover using power tool.
  2. Drain coolant from radiator. Refer to "DRAINING ENGINE COOLANT ".
    CAUTION: Perform when engine is cool.
  3. Remove drive belts. Refer to "DRIVE BELTS ."
  4. Remove water drain plug on water pump side of the engine. Refer to "DRAINING ENGINE COOLANT ."
  5. Disconnect lower radiator hose.
    Fig 1: Identifying Thermostat Assembly
    G04886349Courtesy of NISSAN MOTOR CO., U.S.A.
  6. Remove engine coolant inlet and thermostat assembly.
    • Do not disassemble engine coolant inlet and thermostat. Replace them as a unit, if necessary.
scientia non olet · About LEMON Manuals