Liquid Gasket Application Procedure

WARNING: This page is about a different car, the 2007 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.

Remove old liquid gasket adhering to the liquid gasket application surface and the mating surface, using scraper.

Fig 1: Identifying Scraper
Courtesy of NISSAN MOTOR CO., U.S.A.
- Remove liquid gasket completely from the groove of the liquid gasket application surface, bolts, and bolt holes.
Thoroughly clean the mating surfaces and remove adhering moisture, grease and foreign materials.
Attach liquid gasket tube to Tool.

Fig 2: Applying Genuine RTV Silicone Sealant
Courtesy of NISSAN MOTOR CO., U.S.A.

Tool number: WS39930000 ( - )

Use Genuine RTV Silicone Sealant or equivalent . Refer to "RECOMMENDED CHEMICAL PRODUCTS AND SEALANTS ".
Apply liquid gasket without breaks to the specified location with the specified dimensions.
- If there is a groove for the liquid gasket application, apply liquid gasket to the groove.
As for the bolt holes, normally apply liquid gasket inside the holes. Occasionally, it should be applied outside the holes. Make sure to read the text of service manual.

Fig 3: Applying Bead Of Sealant To Bolt Holes
Courtesy of NISSAN MOTOR CO., U.S.A.
Within five minutes of liquid gasket application, install the mating component.
If liquid gasket protrudes, wipe it off immediately.
Do not retighten nuts or bolts after the installation.
After 30 minutes or more have passed from the installation, fill engine oil and engine coolant.

CAUTION: If there are specific instructions in this manual, observe them.