Connecting Rod Bearing Housing Diameter (Big End)

WARNING: This page is about a different car, the 2007 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.

Install the connecting rod cap without the connecting rod bearing installed. After tightening the connecting rod nut to the specified torque, measure the connecting rod bearing housing big end inner diameter using an inside micrometer.
Standard: 55.000 - 55.013 mm (2.1654 - 2.1659 in)

Fig 1: Checking Connecting Rod Bearing (Big End)

Courtesy of NISSAN MOTOR CO., U.S.A.