LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2004 >> Altima S, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 888 (Engine Mechanical) >> Cylinder Block >> Inspection >> Bearing Clearance >> Connecting Rod Bearing (Big End)

Connecting Rod Bearing (Big End)

WARNING: This page is about a different car, the 2007 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the connecting rod bearing to the connecting rod and cap.
  2. Install the connecting rod cap to the connecting rod. Tighten to specification. Refer to "DISASSEMBLY AND ASSEMBLY ".
  3. Measure the inner diameter "C" of each connecting rod (big end) as shown.
    Fig 1: Checking Inner Diameter Of Connecting Rod (Big End)
    G04886206Courtesy of NISSAN MOTOR CO., U.S.A.
  4. Measure the outer diameter "Dp" of each crankshaft pin journal.
  5. Calculate the connecting rod bearing clearance.

    Connecting rod bearing clearance = C - Dp 

    Standard: 0.034 - 0.059 mm (0.0013 - 0.0023 in) 

    Limit: 0.070 mm (0.0028 in) 

  6. If the calculated clearance exceeds the specified limit, replace the bearings.
  7. If the clearance cannot be adjusted within the standard of any bearing, grind the crankshaft journal and use undersized bearings.
    Fig 2: Checking Outer Diameter Of Each Crankshaft Pin Journal
    G04886207Courtesy of NISSAN MOTOR CO., U.S.A.
  8. If the crankshaft is replaced with a new one, select the connecting rod bearings according to the following table:
scientia non olet · About LEMON Manuals