LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2004 >> Altima S, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 888 (Engine Mechanical) >> Camshaft >> Removal and Installation >> Inspection After Removal >> Camshaft Sprocket Runout

Camshaft Sprocket Runout

WARNING: This page is about a different car, the 2007 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
  1. Put V-block on precise flat bed and support No. 2 and No. 4 journal of camshaft as shown.
  2. Install camshaft sprocket on camshaft.
  3. Measure camshaft sprocket runout.

    Runout: Less than 0.15 mm (0.0059 in) 

  4. If sprocket runout exceeds the limit, replace camshaft sprocket.
    Fig 1: Measuring Camshaft Sprocket Runout With Dial Indicator
    G04878376Courtesy of NISSAN MOTOR CO., U.S.A.
scientia non olet · About LEMON Manuals