LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2004 >> Altima S, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 887 (Power Supply, Ground & Circuit Elements) >> IPDM E/R (Intelligent Power Distribution Module Engine Room) >> Removal and Installation of IPDM E/R >> Removal

Removal and Installation of IPDM E/R: Removal

WARNING: This page is about a different car, the 2007 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect negative battery cable.
  2. Remove engine side cover RH.
  3. Remove 2 bolts and position coolant reservoir aside.
  4. Remove IPDM E/R upper cover.
    Fig 1: Positioning Coolant Reservoir
    G04918609Courtesy of NISSAN MOTOR CO., U.S.A.
  5. Remove IPDM E/R harness cover.
    Fig 2: Identifying IPDM E/R Harness Cover
    G04909417Courtesy of NISSAN MOTOR CO., U.S.A.
  6. Release 2 clips and pull IPDM E/R up from case.
  7. Disconnect IPDM E/R connectors and remove the IPDM E/R.
    Fig 3: Locating IPDM E/R
    G04909418Courtesy of NISSAN MOTOR CO., U.S.A.
scientia non olet · About LEMON Manuals