Inspection with CONSULT-II (Self-Diagnosis)

WARNING: This page is about a different car, the 2007 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: If a CONSULT-II is used with no connection of CONSULT-II CONVERTER, malfunctions might be detected in self-diagnosis depending on which control unit(s) carry out CAN communication.

SELF-DIAGNOSIS RESULT CHECK

Connect CONSULT-II and select "IPDM E/R" on the "Select System" screen.
Select "SELF-DIAG RESULTS" on the "SELECT DIAG MODE" screen.
Check display content in self-diagnosis results.

SELF-DIAGNOSIS RESULTS CHART

CONSULT-II Display	CONSULT-II display code	TIME		Details of diagnosis result
CONSULT-II Display	CONSULT-II display code	CRNT	PAST	Details of diagnosis result
NO DTC IS DETECTED. FURTHER TESTING MAY BE REQUIRED.	-	-	-	No malfunction
CAN COMM CIRC	U1000	X	X	Any of items listed below have errors: TRANSMIT DIAG ECM BCM/SEC

NOTE: The Details for Display for the Period are as follows:

CRNT: Error currently detected by IPDM E/R.
PAST: Error detected in the past and stored in IPDM E/R memory.

Contents displayed

NO DTC DETECTED. FURTHER TESTING MAY BE REQUIRED.: Inspection End.

CAN COMM CIRC: Print out the self diagnosis results and refer to "TROUBLE DIAGNOSIS ".