Auxiliary Mechanism: Inlet Port Memory Function
WARNING: This page is about a different car, the 2007 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
When ignition key is turned from OFF to ON, inlet port can be set to AUTO or manual.
Operating procedures for this trimmer are as follows:
- Begin Self-diagnosis STEP 5 mode. Refer to "A/C SYSTEM SELF-DIAGNOSIS FUNCTION ".
- Press top of blower control switch to set system in auxiliary mode.
- Display shows 61 in auxiliary mechanism. It takes approximately 3 seconds.
- Press the recirculation
(REC) switch as desired.REC SWITCH REFERENCE CHART
Switch LED status of REC switch Setting status Setting changeover method REC ON Manual REC status is memorized. (Initial setting) REC SW: ON OFF Manual FRE status is memorized. REC SW: OFF