Removal and Installation for Condenser: Installation
WARNING: This page is about a different car, the 2007 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
Installation is in the reverse order of removal.
High-pressure flexible hose and pipe bolt: Refer to " COMPONENTS " .
Condenser mounting nuts: 5.0 - 6.79 N.m (0.51 - 0.69 kg-m, 45 - 60 in-lb)
CAUTION:
- Replace the O-rings of the high-pressure pipe, refrigerant pressure sensor, and high-pressure flexible hose with new ones, then apply compressor oil to them when installing them.
- After charging refrigerant, check for leaks. Refer to "CHECKING FOR REFRIGERANT LEAKS ".