CAN Communication Inspection Using CONSULT-II (Self-Diagnosis)

WARNING: This page is about a different car, the 2007 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.

SELF-DIAGNOSTIC RESULT CHECK

CAUTION: If CONSULT-II is used with no connection of CONSULT-II CONVERTER, malfunctions might be detected in self-diagnosis depending on control unit which carries out CAN communication.

Connect to CONSULT-II, and select "AUTO DRIVE POS." on the "SELECT DIAG SYSTEM" screen.
Select "SELF-DIAG RESULTS" on "SELECT DIAG MODE" screen.

Check display content in self-diagnostic results.

CONSULT-II DISPLAY CODE AND DIAGNOSIS ITEM REFERENCE

CONSULT-II display code	Diagnosis item
U1000	INITIAL DIAG
	TRANSMIT DIAG
	ECM
	IPDM E/R
	METER/M&A
	I-KEY

Contents displayed

No malfunction: Inspection End.

Malfunction in CAN communication system: After printing the monitor items, go to "CAN System". Refer to "PRECAUTIONS WHEN USING CONSULT-II ".