LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2004 >> Altima S, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 840 (Parking Brake System) >> Parking Brake Shoe >> Removal and Installation >> Removal

Removal and Installation: Removal

WARNING: This page is about a different car, the 2007 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.
WARNING: Clean the brakes with a vacuum dust collector to minimize the hazard of airborne particles or other materials.
NOTE: Remove the disc rotor only with the parking brake pedal completely disengaged.
  1. Remove the rear disc rotor. Refer to "REMOVAL AND INSTALLATION OF BRAKE CALIPER AND DISC ROTOR ".
  2. Remove the rear drive shaft. Refer to "REMOVAL AND INSTALLATION ".
  3. Disconnect wheel sensor at harness connector. Then remove wheel sensor wire from grommet mounts.
  4. Remove wheel hub and bearing assembly. Refer to "REMOVAL AND INSTALLATION ".
    • Withdraw wheel sensor harness through back plate when removing wheel hub and bearing assembly.
  5. Remove the return springs.
  6. Remove the adjuster.
  7. Remove the retainers, anti-rattle pins and shoes.
  8. Disconnect the parking brake cable from the toggle lever.
  9. Remove back plate.
scientia non olet · About LEMON Manuals