LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2004 >> Altima S, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 840 (Parking Brake System) >> Parking Brake Control >> Removal and Installation >> Removal

Removal and Installation: Removal

WARNING: This page is about a different car, the 2007 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the lower instrument panel LH and center console. Refer to "LOWER INSTRUMENT PANEL LH " and "CENTER CONSOLE ".
  2. Remove the floor trim. Refer to "FLOOR TRIM ".
  3. Remove the parking brake control adjusting nut.
    CAUTION: Do not reuse adjusting nut after removing it.
  4. Remove the lock plate from the front cable.
  5. Remove front parking brake cable bolt and nut.
  6. Disconnect return spring from equalizer.
  7. Disconnect the front parking brake cable from the equalizer and remove front cable.
  8. Remove the rear disc rotors. Refer to "REMOVAL AND INSTALLATION OF BRAKE CALIPER AND DISC ROTOR ".
  9. Remove parking brake shoes, and remove rear cable from toggle lever. Refer to "PARKING BRAKE SHOE ".
  10. Remove equalizer from right and left rear cables.
  11. Remove right and left rear cable bolts and nuts, then remove right and left rear cables.
scientia non olet · About LEMON Manuals