LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2004 >> Altima S, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 834 (Transfer Case) >> TX15B >> Trouble Diagnosis >> CONSULT-II Function (ALL MODE AWD/4WD) >> Self-Diag Result Mode >> Operation Procedure

Operation Procedure

WARNING: This page is about a different car, the 2007 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.
  1. Perform "CONSULT-II SETTING PROCEDURE". Refer to "CONSULT-II START PROCEDURE ".
  2. With engine at idle, touch "SELF-DIAG RESULTS".

    Display shows malfunction experienced since the last erasing operation.

NOTE: The details for "TIME" are as follows:
  • "0": Error currently detected with transfer control unit.
  • Except for "0": Error detected in the past and memorized with transfer control unit.

    Detects frequency of driving after DTC occurs (frequency of turning ignition switch "ON/OFF").

    Fig 1: Identifying CONSULT II - SELF DIAG RESULTS Screen
    G04901461
scientia non olet · About LEMON Manuals