LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2004 >> Altima S, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 834 (Transfer Case) >> ATX14B >> Side Oil Seal >> Removal and Installation >> Installation

Removal and Installation: Installation

WARNING: This page is about a different car, the 2007 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the new side oil seal until it is flush with the end face of case using Tool.

    Tool number : ST22360002 (J-25679-01) 

    CAUTION:
    • Do not reuse oil seal.
    • Apply petroleum jelly to oil seal.
      • Fig 1: Tapping Side Oil Seal
      G04901597
  2. Install the transfer control device to the transfer assembly. Refer to "REMOVAL AND INSTALLATION ".
  3. Install the companion flange. Refer to "INSTALLATION ".
  4. Install the front propeller shaft. Refer to "INSTALLATION ".
scientia non olet · About LEMON Manuals