LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2004 >> Altima S, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 834 (Transfer Case) >> ATX14B >> Front Oil Seal >> Removal and Installation >> Removal

Removal and Installation: Removal

WARNING: This page is about a different car, the 2007 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.
  1. Partially drain the transfer fluid. Refer to "TRANSFER FLUID ".
  2. Remove the front propeller shaft. Refer to "REMOVAL AND INSTALLATION ".
  3. Remove the companion flange self-lock nut using Tool.

    Tool number : KV40104000 ( - ) 

    Fig 1: Identifying Companion Flange Self-Lock Nut
    G04901584
  4. Put a matching mark on top of the front drive shaft in line with the mark on the companion flange.
    CAUTION: Use paint to make the matching mark on the front drive shaft. Do not damage the front drive shaft.
    Fig 2: Aligning Matching Mark Of Front Drive Shaft With Matching Mark Of Companion Flange
    G04901585
  5. Remove the companion flange using suitable tool.
    Fig 3: Identifying Companion Flange
    G04901586
  6. Remove the front oil seal from the front case using Tool.

    Tool number : ST33290001 (J-34286) 

    CAUTION: Do not damage front case.
    Fig 4: Identifying Front Oil Seal
    G04901587
scientia non olet · About LEMON Manuals