Diagnostic Procedure

WARNING: This page is about a different car, the 2007 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.

CHECK BCM CONNECTORS
1. Turn ignition switch OFF.
2. Disconnect BCM harness connectors M18 and M20.
3. Check terminals for damage or loose connections.
Inspection results OK?

OK: GO TO 2.

NG: Repair or replace damaged parts.
CHECK TIRE PRESSURE WARNING CHECK CONNECTOR CIRCUIT
Check continuity between BCM harness connector M18 terminal 15 and check connector M123 terminal 1.

Fig 1: Checking Continuity Between BCM Connector Terminal 15 And Check Connector M123 Terminal 1

Continuity should exist.

OK or NG

OK: Replace BCM. Refer to "BCM ".

NG: Repair or replace harness connector.