Rear Power Window Motor RH Circuit Check

WARNING: This page is about a different car, the 2007 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.

CHECK REAR POWER WINDOW SWITCH RH OUTPUT SIGNAL

Turn ignition switch OFF.
Disconnect rear power window motor RH.
Turn ignition switch ON.

Check voltage between rear power window motor RH connector and ground.

VOLTAGE SPECIFICATION CHART

Connector	Terminals		Condition	Voltage (V) (Approx.)
Connector	(+)	(-)	Condition	Voltage (V) (Approx.)
Rear power window motor RH: D304	1	Ground	UP	0
	1		DOWN	Battery voltage
	2		UP	Battery voltage
	2		DOWN	0

Fig 1: Checking Voltage Between Rear Power Window Motor RH Connector And Ground

OK or NG

OK: Replace rear power window motor RH. Refer to "REAR DOOR GLASS REGULATOR ".

NG: GO TO 2.

CHECK REAR POWER WINDOW MOTOR RH CIRCUIT
1. Turn ignition switch OFF.
2. Disconnect rear power window switch RH.
3. Check continuity between rear power window switch RH connector D303 (A) and rear power window motor RH connector D304 (B).
  6 - 1 : Continuity should exist.
  
  7 - 2 : Continuity should exist.
  
  Fig 2: Continuity Between Rear Power Window Switch RH Connector D303 (A) And RH Connector D304 (B)
OK or NG

OK: GO TO 3.

NG: Repair or replace harness.
CHECK POWER SUPPLY
1. Connect rear power window switch RH.
2. Turn ignition switch ON.
3. Check voltage between rear power window switch RH connector D303 terminal 8 and ground.
  8 - Ground : Battery voltage
  
  Fig 3: Checking Voltage Between Rear Power Window Switch RH Connector D303 Terminal 8 And Ground
OK or NG

OK: Replace rear power window switch RH. Refer to "REAR DOOR ".

NG: Repair or replace harness.