Removal and Installation of Brake Caliper and Disc Rotor: Removal
WARNING: This page is about a different car, the 2007 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.
- Remove wheel and tire using power tool.
- Drain brake fluid as necessary. Refer to
"DRAIN AND REFILL ".NOTE: Do not remove union bolt unless removing cylinder body from vehicle.
- Remove union bolt as necessary and torque member bolts, then remove cylinder body from the vehicle.NOTE:
- Position cylinder body aside using suitable wire, as necessary.
- When servicing brake caliper, remove sliding pin bolts and caliper from torque member.
- Remove torque member.
- Remove disc rotor.