LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2004 >> Altima S, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 823 (Manual Air Conditioner) >> Refrigerant Lines >> Removal and Installation for Compressor Clutch >> Removal

Removal and Installation for Compressor Clutch: Removal

WARNING: This page is about a different car, the 2007 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the compressor. Refer to "REMOVAL AND INSTALLATION FOR COMPRESSOR ".
  2. Remove the center bolt while holding the clutch disc stationary using Tool as shown.

    Tool number : J-44614 

    Fig 1: Locating Center Bolt
    G04903516
  3. Remove the clutch disc.
  4. Remove the snap ring using external snap ring pliers or suitable tool.
    Fig 2: Locating Snap Ring
    G04903517
  5. Remove the pulley using Tool with a small adapter. Position the small adapter on the end of the drive shaft and the center of the puller on the small adapter.

    Tool number : KV99233130 (J-29884) 

    CAUTION: To prevent deformation of the pulley groove, the puller claws should be hooked under the pulley groove and not into the pulley groove.
    Fig 3: Locating Compressor Pulley
    G04903518
  6. Remove the magnet coil harness clip using a screwdriver, remove the three magnet coil fixing screws and remove the magnet coil.
    Fig 4: Locating Magnet Coil
    G04903519
scientia non olet · About LEMON Manuals