Front Door Lock Assembly LH (Actuator) Check

1. Turn ignition switch OFF.
2. Check voltage between BCM connector M20 terminals 59, 65 and ground.
   VOLTAGE CHART
   
   

   Connector	Terminals		Condition	Voltage (V) (Approx.)
   	(+)	(-)
   M20	59	Ground	Driver door lock/unlock switch is turned to UNLOCK	0 --> Battery voltage
   	65		Driver door lock/unlock switch is turned to LOCK	0 --> Battery voltage

   Fig 1: Checking Voltage Between BCM Connector M20 Terminals 59, 65 And Ground

   

OK or NG 

OK: GO TO 2.

NG: Replace BCM. Refer to "REMOVAL AND INSTALLATION ".

1. Disconnect BCM and front door lock assembly LH (actuator).
2. Check continuity between BCM connector M20 terminals 59, 65 and front door lock assembly LH (actuator) connector D14 terminals 1, 2.
   CONTINUITY REFERENCE CHART
   
   

   Connector	Terminals	Connector	Terminals	Continuity
   M20	59	D14	2	Yes
   	65		1	Yes

3. Check continuity between BCM connector M20 terminals 59, 65 and ground.
   CONTINUITY REFERENCE CHART
   
   

   Connector	Terminals		Continuity
   M20	59	Ground	No
   	65		No

   Fig 2: Checking Continuity Between BCM Connector M20 Terminals 59, 65 And Ground

   

OK or NG 

OK: Replace front door lock assembly LH (actuator). Refer to "REMOVAL AND INSTALLATION ".

NG: Repair or replace harness.