Diagnostic Procedure
SYMPTOM: Transmitter does not activate receiver.
Before conducting the procedure given below, make sure that system receiver (garage door opener, etc.) operates with original, hand-held transmitter. If NG, receiver or hand-held transmitter is at fault, not vehicle related.
- ILLUMINATION CHECK
- Turn ignition switch OFF.
- Does red light (LED) of transmitter illuminate when any button is pressed?
Yes or No
YES: GO TO 2.
NO: GO TO 3.
- TRANSMITTER CHECK
Check transmitter with Tool*.
*:For details, refer to Technical Service Bulletin. .
OK or NG
OK: Receiver or hand-held transmitter malfunction, not vehicle related.
NG: Replace transmitter.
- POWER SUPPLY CHECK
- Disconnect transmitter.
- Check voltage between auto anti-dazzling inside mirror connector R7 terminal 10 and ground.
10 - Ground : Battery voltage
OK or NG
OK: GO TO 4.
NG: Repair or replace fuse or harness.
- GROUND CIRCUIT CHECK
Check continuity between auto anti-dazzling inside mirror connector R7 terminal 3 and body ground.
3 - Ground : Continuity should exist.
OK or NG
OK: Replace auto anti-dazzling inside mirror assembly.
NG: Repair or replace harness.