Changing Transfer Fluid: Filling

WARNING: This page is about a different car, the 2007 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.

Remove the filler plug and gasket.
- Check the ATX14B as shown.
  
  Fig 1: Checking Fluid Level (ATX14B)
- Check the TX15B as shown.
  
  Fig 2: Checking Fluid Level (TX15B)
Fill the transfer with new fluid until the fluid level reaches the specified limit near the filler plug hole.
Fluid grade and capacity : Refer to "FLUIDS AND LUBRICANTS ".

CAUTION: Carefully fill fluid. (Fill up for approx. 3 minutes.)
Leave the vehicle for 3 minutes, and check fluid level again.
Install the filler plug with a new gasket to the transfer. Tighten to the specified torque. Refer to "COMPONENTS " (ATX14B), "COMPONENTS " (TX15B).
CAUTION: Do not reuse gasket.