LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2004 >> Altima S, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 820 (Automatic Transmission) >> DTC P0740 Torque Converter Clutch Solenoid Valve >> DTC Confirmation Procedure >> With Consult-II

With Consult-II

WARNING: This page is about a different car, the 2007 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn ignition switch "ON". (Do not start engine.)
  2. Select "DATA MONITOR" mode for "ENGINE" with CONSULT-II.
    Fig 1: Identifying CONSULT II Display - SELECT DIAG MODE
    G04899604
  3. Start engine and maintain the following conditions for at least 5 consecutive seconds.

    VHCL SPEED SE: 80 km/h (50 MPH) or more 

    ACCELE POS: 0.5/8 - 1.0/8 

    SELECTOR LEVER: "D" position 

    Driving location: Driving the vehicle uphill (increased engine load) will help maintain the driving conditions required for this test. 

  4. If DTC is detected go to "DIAGNOSTIC PROCEDURE ".