Liquid Gasket Application Procedure

WARNING: This page is about a different car, the 2007 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.

Using scraper, remove old liquid gasket from gasket application surface and the mating surface.
- Remove liquid gasket completely from the groove of the gasket application surface, bolts, and bolt holes.
  
  Fig 1: Identifying Scraper
  Courtesy of NISSAN MOTOR CO., U.S.A.
Thoroughly clean the mating surfaces and remove moisture, grease and foreign materials.
Attach liquid gasket tube to Tool.
Tool number : WS39930000 (-)

Use Genuine RTV Silicone Sealant or equivalent. Refer to "RECOMMENDED CHEMICAL PRODUCTS AND SEALANTS ".
Apply liquid gasket without breaks to the specified location with the specified dimensions.
- If there is a groove for liquid gasket application, apply liquid gasket to the groove.
  
  Fig 2: Applying Genuine RTV Silicone Sealant
  Courtesy of NISSAN MOTOR CO., U.S.A.
- As for bolt holes, normally apply liquid gasket inside the holes. Occasionally, it should be applied outside the holes. Make sure to read the text of this article.
- Within five minutes of liquid gasket application, install the mating component.
- If liquid gasket protrudes, wipe it off immediately.
- Do not retighten nuts or bolts after the installation.
- After 30 minutes or more have passed from the installation, fill engine oil and engine coolant.
CAUTION: If there are specific instructions in this information, observe them.

Fig 3: Applying Bead Of Sealant To Bolt Holes
Courtesy of NISSAN MOTOR CO., U.S.A.