Inspection After Installation
WARNING: This page is about a different car, the 2007 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.
- Before starting engine, check the levels of engine coolant, engine oil and working fluid. If less than required quantity, fill to the specified level.
- Use procedure below to check for fuel leakage.
- Turn ignition switch ON (with engine stopped). With fuel pressure applied to fuel piping, check for fuel leakage at connection points.
- Start engine. With engine speed increased, check again for fuel leakage at connection points.
- Run engine to check for unusual noise and vibration.
- Warm up engine thoroughly to make sure there is no leakage of engine coolant, engine oil, working fluid, fuel and exhaust gas.
- Bleed air from passages in pipes and tubes of applicable lines, such as in cooling system.
- After cooling down engine, again check amounts of engine coolant, engine oil and working fluid. Refill to specified level, if necessary.
- Summary of the inspection items:
TIGHTENING CHART
| Item | Before starting engine | Engine running | After engine stopped |
|---|---|---|---|
| Engine coolant | Level | Leakage | Level |
| Engine oil | Level | Leakage | Level |
| Working fluid | Level | Leakage | Level |
| Fuel | Leakage | Leakage | Leakage |
| Exhaust gas | - | Leakage | - |
| *Transmission/transaxle/CVT fluid, power steering fluid, brake fluid, etc. | |||