All Signals, Main Signals, Selection From Menu
WARNING: This page is about a different car, the 2007 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.
DISPLAY ITEM LIST - DATA MONITOR
| Item name | CONSULT-II screen display | Display or unit | Monitor item selection | Description | ||||
|---|---|---|---|---|---|---|---|---|
| ALL SIGNALS | MAIN SIGNALS | SELECTION FROM MENU | ||||||
| Motor fan request | MOTOR FAN REQ | 1/2/3/4 | X | X | X | Signal status input from ECM | ||
| Compressor request | AC COMP REQ | ON/OFF | X | X | X | Signal status input from BCM | ||
| Parking, license plate, and tail lamp request | TAIL & CLR REQ | ON/OFF | X | X | X | Signal status input from BCM | ||
| Headlamp low beam request | HL LO REQ | ON/OFF | X | X | X | Signal status input from BCM | ||
| Headlamp high beam request | HL HI REQ | ON/OFF | X | X | X | Signal status input from BCM | ||
| Front fog lamps request | FR FOG REQ | ON/OFF | X | X | X | Signal status input from BCM | ||
| Front wiper request | FR WIP REQ | STOP/1LO/LO/HI | X | X | X | Signal status input from BCM | ||
| Wiper auto stop | WIP AUTO STOP | ACT P/STOP P | X | X | X | Output status of IPDM E/R | ||
| Wiper protection | WIP PROT | OFF/LS/HS/BLOCK | X | X | X | Control status of IPDM E/R | ||
| Starter request | ST RLY REQ | ON/OFF | X | X | Signal status input from BCM | |||
| Ignition relay status | IGN RLY | ON/OFF | X | X | X | Ignition relay status monitored with IPDM E/R | ||
| Rear defogger request | RR DEF REQ | ON/OFF | X | X | X | Signal status input from BCM | ||
| Hood switch | HOOD SW(1) | OFF | X | Signal status input from IPDM E/R | ||||
| Theft warning horn request | THFT HRN REQ | ON/OFF | X | X | Signal status input from BCM | |||
| Horn chirp | HORN CHIRP | ON/OFF | X | X | Output status of IPDM E/R | |||
| Daytime lights request | DTRL REQ | ON/OFF | X | X | Signal status input from BCM | |||
|
||||||||
NOTE:
- Perform monitoring of IPDM E/R data with the ignition switch ON. When the ignition switch is in ACC position, display may not be correct.