LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2004 >> Altima S, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 791 (Seat) >> Front Seat >> Disassembly and Assembly >> Removal Of Seatback Assembly

Removal Of Seatback Assembly

WARNING: This page is about a different car, the 2004 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
  1. After completing the steps 1 and 2 of "Seatback Trim and Pad", remove the harness connectors for the reclining motor and lumbar support motor (driver seat only).
  2. Pull out the harness connector for the side air bag from the seat cushion.
  3. Remove the reclining device mounting bolts (2 for each side) on the seatback frame, and remove the seatback assembly.
    NOTE: When assembling the seatback frame, make sure that the reclining device is locked on both sides, and be sure to temporarily tighten the bolts, then finish tightening them.
scientia non olet · About LEMON Manuals