Section 628 (Rear Axle): Precautions: Precautions

WARNING: This page is about a different car, the 2005 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION:

When installing each rear suspension rubber component, the final fastener tightening must be carried out with the vehicle under unladen condition* with the tires on the ground.
*Fuel, engine coolant and engine oil full. Spare tire, jack, hand tools, and floor mats in designated positions.
After installing suspension components, check the rear wheel alignment.
Do not jack up the vehicle at the rear suspension components.