LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2004 >> Altima S, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 500 (Headlamp (For USA)) >> Headlamp (For USA) >> Headlamp LO Does Not Illuminate (One Side)

Headlamp LO Does Not Illuminate (One Side)

WARNING: This page is about a different car, the 2004 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.
  1. BULB INSPECTION 

    Inspect inoperative headlamp bulb.

    OK or NG

    1. OK: GO TO 2.
    2. NG: Replace headlamp bulb. Refer to "HEADLAMP (OUTER SIDE), FOR LOW BEAM  ".
  2. CHECK POWER TO HEADLAMP 
    1. Disconnect inoperative headlamp connector.
    2. Turn the low beam headlamps ON.
    3. Check voltage between inoperative headlamp connector terminal and ground.
    HEADLAMP TERMINAL 1 VOLTAGE CHART

    Terminals Voltage (Approx.)
    (+) (-)
    Connector Terminal  
    Right E12 1 (R/Y) Ground 12
    Left E44 1(L)

    OK or NG

    1. OK: GO TO 3.
    2. NG: GO TO  4 .
      Fig 1: Checking Voltage Between Inoperative Headlamp Connector Terminal & Ground
      G03500490Courtesy of NISSAN MOTOR CO., U.S.A.
  3. CHECK HEADLAMP GROUND 
    1. Turn the low beam headlamps OFF.
    2. Check continuity between inoperative headlamp connector terminal and ground.
    HEADLAMP TERMINAL 2 CONTINUITY CHART

    Terminals Continuity
    (+) (-)
    Connector Terminal (Wire color)  
    RH E12 2(B) Ground Yes
    LH E44 2(B)

    OK or NG

    1. OK: Check headlamp and IPDM E/R connector. Repair as necessary.
    2. NG: Repair open circuit in harness between inoperative headlamp and ground.
      Fig 2: Checking Continuity Between Inoperative Headlamp Connector Terminal & Ground
      G03500491Courtesy of NISSAN MOTOR CO., U.S.A.
  4. INSPECTION BETWEEN IPDM E/R AND HEADLAMPS 
    1. Disconnect IPDM E/R connector.
    2. Check continuity between harness connector terminals of IPDM E/R harness connector terminals of inoperative headlamp.
    IPDM E/R HARNESS CONNECTOR TERMINAL CONTINUITY CHART

    Terminals Continuity
    IPDM E/R Front combination lamp
    Connector Terminal (Wire color) Connector Terminal (Wire color)
    E122 20(R/Y) RH E12 1 (R/Y) Yes
    30 (L) LH E44 1(L)

    OK or NG

    1. OK: Replace IPDM E/R. Refer to REMOVAL AND INSTALLATION OF IPDM E/R .
    2. NG: Check for short circuits and open circuits in harness between IPDM E/R and headlamps. Repair as necessary.
      Fig 3: Checking Continuity Between Harness Connector Terminals Of IPDM E/R Harness Connector Terminals
      G03500492Courtesy of NISSAN MOTOR CO., U.S.A.