DTC Confirmation Procedure
WARNING: This page is about a different car, the 2012 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
If DTC Confirmation Procedure has been previously conducted, always perform the following before conducting the next step.
- Turn ignition switch OFF and wait at least 10 seconds.
- Turn ignition switch ON.
- Turn ignition switch OFF and wait at least 10 seconds.
TESTING CONDITION:
Before performing the following procedure, confirm that battery voltage is more than 10V at idle .
- Start engine and let it idle for 1 second.
- Check DTC.
- If DTC is detected, go to "DIAGNOSIS PROCEDURE ".