DTC Confirmation Procedure
WARNING: This page is about a different car, the 2012 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Always drive vehicle at a safe speed.
NOTE:
- The procedure for malfunction B is not described. It takes an extremely long time to complete the procedure for malfunction B. By performing the procedure for malfunction A, the condition that causes malfunction B can be detected.
- If DTC Confirmation Procedure has been previously conducted, always perform the following before conducting the next step.
- Turn ignition switch OFF and wait at least 10 seconds.
- Turn ignition switch ON.
- Turn ignition switch OFF and wait at least 10 seconds.
TESTING CONDITION:
Steps 4 and 5 may be conducted with the drive wheels lifted in the shop or by driving the vehicle. If a road test is expected to be easier, it is unnecessary to lift the vehicle .
WITH CONSULT
- Start engine (VDC switch OFF).
- Select "DATA MONITOR" mode with CONSULT.
- Press MAIN switch and make sure that CRUISE indicator illuminates.
- Drive the vehicle for at least 5 consecutive seconds under the following condition.
VHCL SPEED SE More than 30 km/h (19 MPH) Selector lever Suitable position - Check 1st trip DTC.
If DTC is detected, go to "DIAGNOSIS PROCEDURE ".
If DTC is not detected, go to the following step.
- Drive the vehicle for at least 5 consecutive seconds under the following condition.
VHCL SPEED SE More than 30 km/h (19 MPH) Selector lever Suitable position Driving location Depress the brake pedal for more than five seconds so as not to come off from the above-mentioned vehicle speed. - Check 1st trip DTC.
- If DTC is detected, go to "DIAGNOSIS PROCEDURE ".
WITH GST
Follow the procedure "WITH CONSULT" above.