LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2004 >> Altima S, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1183 (Engine Control System - DTCS U0101 To P0183 (VQ40DE)) >> DTC P0125: ECT Sensor >> DTC Confirmation Procedure

DTC Confirmation Procedure

WARNING: This page is about a different car, the 2012 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Never overheat engine.
NOTE: If DTC Confirmation Procedure has been previously conducted, always perform the following before conducting the next step.
  1. Turn ignition switch OFF and wait at least 10 seconds.
  2. Turn ignition switch ON.
  3. Turn ignition switch OFF and wait at least 10 seconds.

WITH CONSULT

  1. Turn ignition switch ON.
  2. Select "DATA MONITOR" mode with CONSULT.
  3. Check that "COOLAN TEMP/S" is above 20°C (68°F).

    If the temperature is above 20°C (68°F), the test result will be OK  .

    If the temperature is below 20°C (68°F), go to following step  .

  4. Start engine and run it for 65 minutes at idle speed.

    If "COOLAN TEMP/S" increases to more than 20°C (68°F) within 65 minutes, stop engine because the test result will be OK  .

  5. Check 1st trip DTC.
  6. If 1st trip DTC is detected, go to "DIAGNOSIS PROCEDURE ".

WITH GST

Follow the procedure "WITH CONSULT" above.

scientia non olet · About LEMON Manuals