Diagnosis Procedure

WARNING: This page is about a different car, the 2012 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.

INSPECTION START
With CONSULT
1. Turn ignition switch ON.
2. Select "SELF-DIAG RESULTS" mode with CONSULT.
3. Touch "ERASE".
4. Perform DTC Confirmation Procedure .
  See "DTC CONFIRMATION PROCEDURE ".
5. Is the DTC P0607 displayed again?
With GST
1. Turn ignition switch ON.
2. Select "Service $04" with GST.
3. Perform DTC Confirmation Procedure .
  See "DTC CONFIRMATION PROCEDURE ".
4. Is the DTC P0607 displayed again?
Yes or No

Yes: GO TO 2.

No: INSPECTION END
REPLACE ECM
1. Replace ECM.
2. Perform initialization of NVIS (NATS) system and registration of all NVIS (NATS) ignition key IDs. Refer to "ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT: SPECIAL REPAIR REQUIREMENT " (with Intelligent Key system) or "ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT: SPECIAL REPAIR REQUIREMENT " (without Intelligent Key system).
3. Perform "VIN REGISTRATION ".
4. Perform "ACCELERATOR PEDAL RELEASED POSITION LEARNING ".
5. Perform "THROTTLE VALVE CLOSED POSITION LEARNING ".
6. Perform "IDLE AIR VOLUME LEARNING ".
INSPECTION END