DTC Confirmation Procedure

WARNING: This page is about a different car, the 2012 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: If DTC Confirmation Procedure has been previously conducted, always perform the following before conducting the next step.

Turn ignition switch OFF and wait at least 10 seconds.
Turn ignition switch ON.
Turn ignition switch OFF and wait at least 10 seconds.
TESTING CONDITION:

Perform "DTC WORK SUPPORT" when the fuel level is between 1/4 and 3/4 full, and vehicle is placed on flat level surface .
Always perform test at a temperature of 0 to 30°C (32 to 86°F) .

WITH CONSULT

Turn ignition switch ON.
Turn ignition switch OFF and wait at least 10 seconds.
Turn ignition switch ON and select "DATA MONITOR" mode with CONSULT.
Make sure that the following conditions are met.
COOLAN TEMP/S: 0 - 70°C (32 - 158°F)

INT/A TEMP SE: 0 - 30°C (32 - 86°F)
Select "EVP V/S LEAK P0456/P1456" of "EVAPORATIVE SYSTEM" in "DTC WORK SUPPORT" mode with CONSULT.
Follow the instructions displayed.

NOTE: If the engine speed cannot be maintained within the range displayed on the CONSULT screen, go to "BASIC INSPECTION ".
Make sure that "OK" is displayed.

If "NG" is displayed, refer to "DIAGNOSIS PROCEDURE ".

NOTE: Make sure that EVAP hoses are connected to EVAP canister purge volume control solenoid valve properly.

WITH GST

NOTE: Be sure to read the explanation of Driving Pattern ON "SRT SET DRIVING PATTERN " before driving vehicle.

Start engine.
Drive vehicle according to Driving Pattern, "DIAGNOSIS DESCRIPTION: DRIVING PATTERN ".
Stop vehicle.
Turn ignition switch OFF, wait at least 10 seconds.
Turn ignition switch ON.
Turn ignition switch OFF, wait at least 10 seconds and then turn ON.
Select Service $07 with GST.

If P0442 is displayed on the screen, go to "DIAGNOSIS PROCEDURE ".
If P0441 is displayed on the screen, go to "DIAGNOSIS PROCEDURE ".