LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2004 >> Altima S, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1182 (Engine Control System - DTCS P0222 To P0607 (VQ40DE)) >> DTC P0335: CKP Sensor (Pos) >> DTC Confirmation Procedure

DTC Confirmation Procedure

WARNING: This page is about a different car, the 2012 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: If DTC Confirmation Procedure has been previously conducted, always perform the following before conducting the next step.
  1. Turn ignition switch OFF and wait at least 10 seconds.
  2. Turn ignition switch ON.
  3. Turn ignition switch OFF and wait at least 10 seconds.

    TESTING CONDITION: 

    Before performing the following procedure, confirm that battery voltage is more than 10.5V with ignition switch ON  .

  1. Crank engine for at least 2 seconds and run it for at least 5 seconds at idle speed.
  2. Check 1st trip DTC.
  3. If 1st trip DTC is detected, go to "DIAGNOSIS PROCEDURE ".
scientia non olet · About LEMON Manuals