LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2004 >> Altima S, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1179 (Engine Control System - DTCS P0181 To P0550 (VK56DE)) >> DTC P050E: Cold Start Control >> Diagnosis Procedure

Diagnosis Procedure

WARNING: This page is about a different car, the 2012 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.
  1. PERFORM IDLE AIR VOLUME LEARNING

    Perform "IDLE AIR VOLUME LEARNING ".

    Is Idle Air Volume Learning carried out successfully? 

    YES: GO TO 2.

    NO: Follow the instruction of Idle Air Volume Learning.

  2. CHECK INTAKE SYSTEM

    Check for the cause of intake air volume lacking. Refer to the following.

    • Crushed intake air passage
    • Intake air passage clogging
    • Clogging of throttle body

    Is the inspection result normal? 

    YES: GO TO 3.

    NO: Repair or replace malfunctioning part

  3. CHECK FUEL INJECTION SYSTEM FUNCTION

    Perform DTC Confirmation Procedure for DTC P0171, P0174. Refer to "ON BOARD DIAGNOSIS LOGIC ".

    Is the inspection result normal? 

    YES: GO TO 4.

    NO: Proceed to "DIAGNOSIS PROCEDURE " for DTC P0171, P0174.

  4. PERFORM DTC CONFIRMATION PROCEDURE
    1. Turn ignition switch ON.
    2. Erase DTC.
    3. Perform DTC Confirmation Procedure.

    See "DTC LOGIC ".

    Is the 1st trip DTC P050E displayed again? 

    YES: GO TO 5.

    NO: INSPECTION END

  5. REPLACE ECM

    Replace ECM. Refer to "ENGINE CONTROL COMPONENT PARTS LOCATION " and "PROCEDURE AFTER REPLACING ECM ".

    INSPECTION END