Diagnosis Procedure

WARNING: This page is about a different car, the 2012 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.

CHECK DTC WITH TCM
Refer to "OBD-II DIAGNOSTIC TROUBLE CODE (DTC) ".

OK or NG

OK: GO TO 2.

NG: Repair or replace malfunctioning part.
CHECK STARTING SYSTEM
Turn ignition switch OFF, then turn it to START.

Does starter motor operate?

Yes or No

Yes: GO TO 3.

No: Refer to "WORK FLOW ".
CHECK PNP SIGNAL CIRCUIT FOR OPEN AND SHORT
1. Turn ignition switch OFF.
2. Disconnect ECM harness connector.
3. Disconnect combination meter harness connector.
4. Check harness continuity between ECM terminal 102 and combination meter terminal 7.
  Refer to WIRING DIAGRAM .
  
  Continuity should exist .
5. Also check harness for short to ground and short to power.
OK or NG

OK: GO TO 5.

NG: GO TO 4.
DETECT MALFUNCTIONING PART
Check the following.
- Harness connectors M31, E152
- Harness for open or short between ECM and combination meter
Repair open circuit or short to ground or short to power in harness or connectors.
CHECK INTERMITTENT INCIDENT
Refer to "INTERMITTENT INCIDENT ".

OK or NG

OK: GO TO 6.

NG: Repair or replace malfunctioning part.
REPLACE COMBINATION METER FUNCTION
Refer to "REMOVAL AND INSTALLATION ".

>> INSPECTION END