Diagnosis Procedure
WARNING: This page is about a different car, the 2009 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK DTC WITH TCM
Refer to "DTC INDEX ".
Is the inspection result normal?
YES: GO TO 2.
NO: Repair or replace malfunctioning part.
- CHECK PNP SIGNAL CIRCUIT FOR OPEN AND SHORT-I
- Turn ignition switch OFF.
- Disconnect TCM harness connector.
- Disconnect IPDM E/R harness connector.
- Check the continuity between TCM harness connector and IPDM E/R harness connector.CONTINUITY CHART
TCM IPDM E/R Continuity Connector Terminal Connector Terminal F15 20 F10 72 Existed - Also check harness for short to ground and short to power.
Is the inspection result normal?
YES: GO TO 3.
NO: Repair open circuit, short to ground or short to power in harness or connectors.
- CHECK PNP SIGNAL CIRCUIT FOR OPEN AND SHORT-II
- Disconnect IPDM E/R harness connectors.
- Disconnect ECM harness connector.
- Check the continuity between ECM harness connector and IPDM E/R harness connector.CONTINUITY CHART
ECM IPDM E/R Continuity Connector Terminal Connector Terminal E10 102 E18 30 Existed - Also check harness for short to ground and short to power.
Is the inspection result normal?
YES: GO TO 5.
NO: GO TO 4.
- DETECT MALFUNCTIONING PART
Check the following.
- Junction block harness connectors E45, E50
- Harness for open or short between ECM and IPDM E/R
: Repair or replace harness or connectors.
- CHECK INTERMITTENT INCIDENT
Refer to "INTERMITTENT INCIDENT ".
Is the inspection result normal?
YES: Replace IPDM E/R.
NO: Repair or replace malfunctioning part.