LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2004 >> Altima S, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1167 (Engine Control System - DTCS P1225 To P2A03) >> P1805 Brake Switch >> Component Inspection (Stop Lamp Switch)

Component Inspection (Stop Lamp Switch)

WARNING: This page is about a different car, the 2009 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
  1. CHECK STOP LAMP SWITCH-I
    1. Turn ignition switch OFF.
    2. Disconnect stop lamp switch harness connector.
    3. Check harness continuity between stop lamp switch terminals under the following conditions.
      CONTINUITY CHART

      Terminals Condition Continuity
      3 and 4 Brake pedal Fully released Not existed
      Slightly depressed Existed
      Fig 1: Checking Harness Continuity Between Stop Lamp Switch Terminals
      G05869942Courtesy of NISSAN MOTOR CO., U.S.A.

    Is the inspection result normal? 

    YES: INSPECTION END

    NO: GO TO 2.

  2. CHECK STOP LAMP SWITCH-II
    1. Adjust stop lamp switch installation. Refer to "INSPECTION AND ADJUSTMENT ".
    2. Check harness continuity between stop lamp switch terminals under the following conditions.
      CONTINUITY CHART

      Terminals Condition Continuity
      3 and 4 Brake pedal Fully released Not existed
      Slightly depressed Existed
      Fig 2: Checking Harness Continuity Between Stop Lamp Switch Terminals
      G05869943Courtesy of NISSAN MOTOR CO., U.S.A.

    Is the inspection result normal? 

    YES: INSPECTION END

    NO: Replace stop lamp switch.

scientia non olet · About LEMON Manuals