Component Inspection

WARNING: This page is about a different car, the 2009 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.

CHECK ASCD STEERING SWITCH

Turn ignition switch OFF.
Disconnect combination switch (spiral cable) harness connector.
Check resistance between combination switch harness connector terminals as per the following.

RESISTANCE REFERENCE

Combination switch	Condition	Resistance (Ω)
Terminals	Condition	Resistance (Ω)
13 and 16	MAIN switch: Pressed	Approx. 0
	CANCEL switch: Pressed	Approx. 250
	SET/COAST switch: Pressed	Approx. 660
	RESUME/ACCELERATE switch: Pressed	Approx. 1, 480
	All ASCD steering switches: Released	Approx. 4, 000

Fig 1: Checking Resistance Between Combination Switch Harness Connector Terminals

Courtesy of NISSAN MOTOR CO., U.S.A.

Is the inspection result normal?

YES: INSPECTION END

NO: Replace ASCD steering switch