Component Inspection

WARNING: This page is about a different car, the 2009 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.

CHECK CAMSHAFT POSITION SENSOR (PHASE)-I
1. Turn ignition switch OFF.
2. Loosen the fixing bolt of the sensor.
3. Disconnect camshaft position sensor (PHASE) harness connector.
4. Remove the sensor.
5. Visually check the sensor for chipping.
Is the inspection result normal?

YES: GO TO 2.

NO: Replace malfunctioning camshaft position sensor (PHASE).

Fig 1: Identifying Sensor For Chipping
Courtesy of NISSAN MOTOR CO., U.S.A.

CHECK CAMSHAFT POSITION SENSOR (PHASE)-II

Check resistance camshaft position sensor (PHASE) terminals as per the following.

RESISTANCE REFERENCE

Terminal No. (Polarity)	Resistance
1 (+) - 2 (-)	Except 0 or ∞Ω [at 25°C (77°F)]
1 (+) - 3 (-)
2 (+) - 3 (-)

Fig 2: Checking Resistance Camshaft Position Sensor Terminals

Courtesy of NISSAN MOTOR CO., U.S.A.

Is the inspection result normal?

YES: INSPECTION END

NO: Replace malfunctioning camshaft position sensor (PHASE).