With Consult-II

WARNING: This page is about a different car, the 2007 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.

Turn ignition switch ON.

Select "P/N POSI SW" in "DATA MONITOR" mode with CONSULT-II. Then check the "P/N POSI SW" signal under the following conditions.

Fig 1: Identifying CONSULT-II Display - DATA MONITOR

Courtesy of NISSAN NORTH AMERICA, INC.

SELECTOR LEVER POSITION

Position (Selector lever)	Known-good signal
P or N position	ON
Except above position	OFF

If NG, go to "DIAGNOSTIC PROCEDURE ".

If OK, go to following step.

Select "DATA MONITOR" mode with CONSULT-II.

Fig 2: Identifying CONSULT-II Display - DATA MONITOR
Courtesy of NISSAN NORTH AMERICA, INC.
Start engine and warm it up to normal operating temperature.

Maintain the following conditions for at least 60 consecutive seconds.

ENGINE SPEED CONDITION CHART

ENG SPEED	1, 400 - 6, 375 rpm
COOLAN TEMP/S	More than 70°C (158°F)
B/FUEL SCHDL	2.0 - 31.8 msec
VHCL SPEED SE	More than 64 km/h (40 MPH)
Selector lever	Suitable position

If 1st trip DTC is detected, go to "DIAGNOSTIC PROCEDURE ".