With Consult-II

WARNING: This page is about a different car, the 2007 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.

Turn ignition switch ON and wait at least 1 second.

Fig 1: Identifying CONSULT-II Display - DATA MONITOR

Courtesy of NISSAN NORTH AMERICA, INC.

Select "DATA MONITOR" mode with CONSULT-II.
Start engine and let it idle for 1 second.
Turn ignition switch OFF, wait at least 10 seconds, and then turn ON.
Repeat steps 3 and 4 for 4 times.
If 1st trip DTC is detected, go to "DIAGNOSTIC PROCEDURE ".