With Consult-II

WARNING: This page is about a different car, the 2007 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.

Start engine (VDC switch OFF).
Read "VHCL SPEED SE" in "DATA MONITOR" mode with CONSULT-II. The vehicle speed on CONSULT-II should exceed 10 km/h (6 MPH) when rotating wheels with suitable gear position.
If NG, go to "DIAGNOSTIC PROCEDURE ".

If OK, go to following step.
Select "DATA MONITOR" mode with CONSULT-II.

Fig 1: Identifying CONSULT-II Display - DATA MONITOR
Courtesy of NISSAN NORTH AMERICA, INC.
Warm engine up to normal operating temperature.

Maintain the following conditions for at least 60 consecutive seconds.

ENGINE SPEED CONDITION CHART

ENG SPEED	1, 700 - 6, 000 rpm
COOLAN TEMP/S	More than 70°C (158°F)
B/FUEL SCHDL	6.3 - 31.8 msec
Selector lever	Except P or N position
PW/ST SIGNAL	OFF

If 1st trip DTC is detected, go to "DIAGNOSTIC PROCEDURE ".