LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2004 >> Altima S, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1159 (Engine Control System - DTCS P0171 To P0453) >> DTC P0447 EVAP Canister Vent Control Valve >> Component Inspection >> EVAP Canister Vent Control Valve >> Without CONSULT-II

Without CONSULT-II

WARNING: This page is about a different car, the 2007 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove EVAP canister vent control valve from EVAP canister.
  2. Check portion B  of EVAP canister vent control valve for being rusted.
    Fig 1: Checking Portion B Of EVAP Canister Vent Control Valve
    G04875240Courtesy of NISSAN NORTH AMERICA, INC.
  3. Check air passage continuity and operation delay time under the following conditions.
    Fig 2: Checking Air Passage Continuity
    G04875242Courtesy of NISSAN NORTH AMERICA, INC.

    Make sure new O-ring is installed properly. 

    CONTINUITY REFERENCE CHART

    Condition Air passage continuity between (A) and (B)
    12V direct current supply between terminals 1 and 2 No
    OFF Yes

    Operation takes less than 1 second. 

    If NG, replace EVAP canister vent control valve.

    If OK, go to next step.

  4. Clean the air passage (portion A  to B  ) of EVAP canister vent control valve using an air blower.
  5. Perform step  3 again.