LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2004 >> Altima S, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1158 (Engine Control System - DTCS U1000 To P0159) >> DTC P0037, P0038, P0057, P0058 Ho2S2 Heater >> DTC Confirmation Procedure >> With Consult-II

With Consult-II

WARNING: This page is about a different car, the 2007 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn ignition switch ON and select "DATA MONITOR" mode with CONSULT-II.
  2. Start engine and warm it up to the normal operating temperature.
  3. Turn ignition switch OFF and wait at least 10 seconds.
  4. Start the engine and keep the engine speed between 3, 500 rpm and 4, 000 rpm for at least 1 minute under no load.
  5. Let engine idle for 1 minute.
  6. If 1st trip DTC is detected, go to "DIAGNOSTIC PROCEDURE ".
    Fig 1: Identifying CONSULT-II Display - DATA MONITOR
    G04894667Courtesy of NISSAN NORTH AMERICA, INC.
scientia non olet · About LEMON Manuals