LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2004 >> Altima S, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1158 (Engine Control System - DTCS U1000 To P0159) >> DTC P0011, P0021 IVT Control >> DTC Confirmation Procedure >> With Consult-II

With Consult-II

WARNING: This page is about a different car, the 2007 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn ignition switch ON and select "DATA MONITOR" mode with CONSULT-II.
  2. Start engine and warm it up to the normal operating temperature.
  3. Maintain the following conditions for at least 6 consecutive seconds. Hold the accelerator pedal as steady as possible.
    ENGINE SPEED CONDITION CHART

    ENG SPEED 1, 200 - 2, 000 rpm
    COOLAN TEMP/S More than 60°C (140°F)
    B/FUEL SCHDL More than 3.5 msec
    Selector lever P or N position
  4. Stop vehicle with engine running and let engine idle for 10 seconds.
  5. If the 1st trip DTC is detected, go to "DIAGNOSTIC PROCEDURE ". If the 1st trip DTC is not detected, go to next step.
  6. Maintain the following conditions for at least 20 consecutive seconds.
    ENGINE SPEED CONDITION CHART

    ENG SPEED 1, 700 - 3, 175 rpm (A constant rotation is maintained.)
    COOLAN TEMP/S More than 70°C (158°F)
    Selector lever 1st or 2nd position
    Driving location uphill Driving vehicle uphill (Increased engine load will help maintain the driving conditions required for this test.)
    Fig 1: Identifying CONSULT-II Display - DATA MONITOR
    G04895421Courtesy of NISSAN NORTH AMERICA, INC.
  7. If the 1st trip DTC is detected, go to "DIAGNOSTIC PROCEDURE ".
scientia non olet · About LEMON Manuals