LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2004 >> Altima S, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1134 (Engine Control System - DTCS U1000 To P0153) >> DTC P0031, P0032, P0051, P0052 A/F Sensor 1 Heater >> DTC Confirmation Procedure

DTC Confirmation Procedure

WARNING: This page is about a different car, the 2008 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: If DTC Confirmation Procedure has been previously conducted, always perform the following before conducting the next step.
  1. Turn ignition switch OFF and wait at least 10 seconds.
  2. Turn ignition switch ON.
  3. Turn ignition switch OFF and wait at least 10 seconds.

TESTING CONDITION: 

Before performing the following procedure, confirm that battery voltage is between 10.5V and 16V at idle  .

WITH CONSULT-III 

  1. Start engine and let it idle for at least 10 seconds.
  2. Check 1st trip DTC.
  3. If 1st trip DTC is detected, go to "DIAGNOSTIC PROCEDURE "
scientia non olet · About LEMON Manuals