Procedure For Malfunction C

WARNING: This page is about a different car, the 2007 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.

With CONSULT-II

Turn ignition switch ON and wait at least 1 second.
Select "DATA MONITOR" mode with CONSULT-II.
Set shift lever to D position and wait at least 2 seconds.
Set shift lever to N, P position.
Start engine and let it idle for 3 seconds.
If DTC is detected, go to "DIAGNOSTIC PROCEDURE ."

Fig 1: CONSULT-II Display - Data Monitor
Courtesy of NISSAN MOTOR CO., U.S.A.

With GST

Follow the procedure "With CONSULT-II" above.